Indesit LFF 8M121 OCX EU Instrukcja Obsługi Strona 28

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 27
EN
28
Troubleshooting
Whenevertheappliancefailstowork,checkforasolutionfromthefollowinglistbeforecallingforAssistance.
* Only available in selected models.
Problem: Possible causes / Solutions:
The dishwasher does not start or cannot
be controlled.
• SwitchofftheappliancebypressingtheON/OFFbutton,switchitback
on after approximately one minute and reset the cycle.
• Theappliancehasnotbeenpluggedinproperly.
• Thedishwasherdoorhasnotbeenshutproperly.
The door won’t close.
• Thelockwasreleased.Stronglypushthedooruntila“clacking”noise
is heard.
No water drains from the
dishwasher.
• Thedishwashercyclehasnotyetfinished.
• Thewaterinlethoseisbent(see Installation).
• Thedrainductisblocked.
• Thefilteriscloggedupwithfoodresidues.
The dishwasher makes excessive
noise.
• Thedishesarerattlingagainsteachotheroragainstthesprayerarms.
• Anexcessiveamountoffoamhasbeenproduced:thedetergenthasnot
been measured out correctly or it is not suitable for use in dishwashers
(see Start-up and use).
The dishes and glasses are
covered in a white film or
limescale deposits.
• Thelevelofrefinedsaltisloworthedosagesettingisnotsuitedtothe
hardness of the water (see Rinse aid and salt).
• Thelidonthesaltdispenserisnotclosedproperly.
• Therinseaidhasbeenuseduporthedosageistoolow.
The dishes and glasses are
streaked or have a bluish tinge.
• Therinseaiddosageistoohigh.
The crockery has not been dried
properly.
• Awashcyclewithoutadryingcyclehasbeenselected.
• Therinseaidhasbeenuseduporthedosageistoolow(see Rinse aid
and salt).
• Therinseaiddispensersettingisnotsuitable.
• Thecrockeryismadefromnon-stickmaterialorplastic.
The dishes are not clean. • Theracksareoverloaded(see Loading the racks).
• Thecrockeryhasnotbeenarrangedproperly.
• Thesprayerarmscannotrotatefreely.
• Thewashcycleistoogentle(see Wash cycles).
• Anexcessiveamountoffoamhasbeenproduced:thedetergenthasnot
been measured out correctly or it is not suitable for use in dishwashers
(see Start-Up and Use).
• Thelidontherinseaidcompartmenthasnotbeenshutcorrectly.
• Thefilterisdirtyorblocked(see Care and maintenance).
• Therefinedsaltlevelislow(see Rinse aid and salt).
• SwitchofftheappliancebypressingtheON/OFFbutton.Shutoffthe
water tap to eliminate the risk of flooding and remove the plug from the
electrical socket.
Make sure the water inlet filter has not become blocked by impurities
(see“Careandmaintenance”chapter).
The dishwasher does not take any
water in - Tap shut-off alarm
(indicatorlightON/OFFashing;H2O and
tap symboldisplayed;F 6 appears after a
few seconds).
• Thereisnowaterinthemainssupply.
• Thewaterinlethoseisbent(seeInstallation).
• Turnonthetapandtheappliancewillstartafterafewminutes.
• Theappliancelockhasbeenactivatedbecausenoactionwastaken
when the beeps sounded.
Switch off the appliance using the ON/OFF button, turn on the tap and
switch the appliance back on after a few seconds by pressing the same
button. Re-program the appliance and restart the wash cycle.
Clogged lter alarm
The“lter”symbolonthedisplaywilllight
up.
• Makesurethewashcyclehasended,openthedishwasherdoor
andcleanthecupfilterandstainless-steelfilter(see“Careand
maintenance”chapter).The“blockedfilter”symbolwillgooffwhenthe
following cycle starts.
Przeglądanie stron 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 83 84

Komentarze do niniejszej Instrukcji

Brak uwag