Indesit PZF 950 T GH N /HA Instrukcja Obsługi Pobierz pdf (Strona 16)

BUILT-IN HOB

HEIGHT = STEEL THICKNESS

BUILT-IN HOB

STEEL THICKNESS < HEIGHT < 68 mm

SUPPORTING SURFACE – ON HOB

HEIGHT > 68 mm

Fitting the hob to the cabinet

There are three different groups of appliance as far as

installation is concerned:

1- Built-in hobs (Class 3) (see figure 2, detail H1); in

this case it is necessary to make a hole with

measurements matching those stated in figure 4a.

Before fitting the hob to the worktop, position the

seal provided along the perimeter of the hob, as

illustrated in figure 4b. Brackets for fixing hobs to

the cabinet have been provided, and these

should be fitted as shown in detail S(Fig. 3).

Fig. 2

Fig. 3

Fig. 1

Min. 700mm

Min. 50mm

Min. 50m

2- Built-in hobs (Class 3) with edges lower than 68

mm (see figure 2, detail H2); to install this type of

hob, a hole large enough to accommodate the

whole lower casing of the appliance must be

made on the worktop intended to be under the

hob. Remember to leave a gap of at least 1 cm

between the lower casing and the worktop around

the whole perimeter of the appliance (the

underside of the casing can, however, touch the

surface below it). To fit the appliances, follow the

instructions given above in point 1 or use any

supplementary instruction leaflet that is provided

in special cases.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 63 64

Brak uwag

Indesit PZF 950 T GH N /HA Instrukcja Obsługi Strona 16